Polymers, Inc. - Hydroseeding and Erosion Control

Hydroseeding and Erosion Control Polymer

PIDG-PAM Hydroseeding PAM is a linear polymer that electrochemically binds soil particles and other constituents of any hydroseeding or Hydromulching system together to provide easier pumping, superior soil stabilization, increased water penetration and better germination.

PIDG-PAM is dissolved in water then spray-applied to the surface to be seeded. It will penetrate into the soil. Within a few hours, it will cause the soil particles to bind together and form a stabilized layer on top of the soil. As a result, all wetted particles such s seeds, soil conditioners, and fertilizer become bound to the surface. The stabilized layer of the soil remains absolutely water permeable and the soil biology is not impaired.

By keeping the soil in place, by protecting against wind water and water erosion, and keeping fertilizer in place and available to the plant, PAM creates an ideal environment for seed germination.

PIDG-PAM replaces the guar gum once used, it took guar 40-60 lbs per acre whereas PAM is applied at a rate of 3 lbs per acre.

Directions for use:

Introduce the appropriate amounts of PIDG-PAM into the Hydro-mulching mixing tank after al the other components are added, agitate mixture thoroughly. The total amount added to an area will vary depending on the area to be covered as shown in the table below and desired viscosity of the mix.

Application rates
1,000 sq. ft	1 oz.
10,000 sq. ft	11 oz.
25,000 sq. ft	1 lb. 11 oz.
43,560 sq. ft	3 lbs.

Other information:

MSDS click here

http://www.watersorb.com/pam_1.htm

http://www.watersorb.com/PAM info inserts.htm

http://www.watersorb.com/pam_2.htm

http://www.watersorb.com/Pam%20%204.htm

Brief History of PAM

Precautionary statements:

PIDG-PAM exhibits a very low degree of toxicity. Few precautions are necessary when handling. Wash with soap and water after contact. Prolonged repeated skin contact may cause irritation/dry skin. Eye contact will cause irritation. Keep out of reach of children.

Spill clean up:

WS Pam spills should be cleaned up without the use of water due to resulting slippery conditions. Thoroughly collect spilled granular material. Flush residuals to the drain with water for normal biological wastewater treatment.

Limit of liability:

These statements, including all descriptions of products and methods, test results and suggestions, are provided for determining the appropriate application of any products, method, or suggestions and for adoption of such precautions against damage. The information contained herein is not to be construed to constitute the permission, recommendation or encouragements of any use of application that may infringe any patents now or hereafter in existence. NO warranty of merchantability or warranty of suitability of fitness for particular purposes is made by Polymers, Inc./Watersorb. No warrant, expressed or implied is made by Watersorb except as may be provided in the sales contract or invoice applicable to the goods in question.

Visit the HTPA site for a hydroseeder in your area.